BCN 4431 Structural Design II
Spring 2021
Class Project
Design the beam and column system shown in the figure below (NOTE: The support conditions
are not realistic and are only used for class purpose to simplify structural analysis and design
process). Check for flexure, shear and deflection in beam. Whenever you use code, please also
report the page number that you referred to and the values that you are looking into. Units should
be mentioned wherever applicable. All intermediate steps should be shown for partial credit.
Legend:
Symbol Meaning
Beam section
Column section
Bracing at center of the beam span
Concentrated load
Uniformly distributed load
Hinge support
Roller support
Fixed support
(20+x) k
(10+x) k
DL: (20 + x) k
LL: (10 + x) k
(30 + x) ft Span = (30 + x) ft long
Your Panther ID governs the value of x. If your PID is 3456789 then, x = 3.45. x is a number
less than 10 with two decimal places.
i.e. x = .
Use steel with Fy = 50 ksi. Allowable deflection is 1/360 of the span of the beam.
Assume that the sections W 21 x 62 are available to you for no cost.
Assume the cost of steel for any other sections = $ 4.2/lb. (finished).
In case you do not find a relevant constant for a loading condition (Cb, Cv or C1), use the constant
that corresponds to the worst case scenario. (NOTE: The only intent of this instruction is to
simplify the problem. Calculated values of the constants MUST be used in real design.)
Please calculate,
i) Minimum cost of the beam system (when W 21 x 62 is free)
ii) Most economic cost of the beam system if the sections W 21 x 62 were not freely available
iii) Most economical cost of column system.